Component Location Index

...

Troubleshooting

Special Tools Required Vacuum Pump/Gauge, 0-”30 inHg Snap-on YA4000A or equivalent commercially available NOTE: - Check the vacuum hoses and the lines for damage and proper connections befor ...

See also:

Driveshaft Installation
NOTE: Before starting Installation, make sure the mating surfaces of the joint and the splined section are clean. 1 Apply about 5 g (0.18 oz) of moly 60 paste (P/N 08734-0001) to the contact area ...

Backlash Inspection
1. Place the differential assembly on V-blocks (A), and install the intermediate shaft (B) and the left driveshaft (C). 2. Measure the backlash of both pinion gears (D) with a dial indicator (E) ...

Preparing to Drive
You should do the following checks and adjustments before you drive your vehicle. 1. Make sure all windows, mirrors, and outside lights are clean and unobstructed. Remove frost, snow, or ic ...