Honda Accord: Engine Mount Control
System
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Engine Electrical / Engine Mount Control
System
Clutch Pedal Position Switch
Replacement
M/T model
1 Disconnect the clutch pedal position switch connector
(A).
2. Loosen the locknut (B), then remove the clutch pedal
position switch (C).
3. Install the clutch pedal position switch ...
See also:
Mainshaft Inspection
1. Inspect the gear and bearing contact areas for wear
and damage, then measure the mainshaft at points A,
B, C, D, and E. If any part of the mainshaft is less than
the service limit, replace it.
...
A/C Condenser Replacemen
1. Recover the refrigerant with a recovery/recycling
charging station (see page 21-80).
2. Remove the front grille cover (see page 20-274).
3. Remove the intake air duct and the water separator ...
Lower Arm A Replacement
1. Raise and support the vehicle (see page 1-13).
2. Remove the rear wheel.
3. Remove the parking brake cable mounting bolt (B).
4. Remove the lower arm A mounting bolts, then
remove lower a ...