Honda Accord: Connecting Rod Bolt Inspection - Engine Block - Engine Mechanical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Connecting Rod Bolt Inspection

1. Measure the diameter of each connecting rod bolt at point A and point B.

2. Calculate the difference in diameter between point A


2. Calculate the difference in diameter between point A and point B.

Point A-”Point B = Difference in Diameter

Difference in Diameter

Specification: 0-”0.1 mm (0-”0.004 in)

3. If the difference in diameter is out of specification, replace the connecting rod bolt.

    Piston Installation
    If the Crankshaft is Already Installed 1. Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. 2. Remove the connecting rod caps, then install the ring co ...

    Crankshaft Installation
    Special Tools Required Driver Handle, 15 x 135L 07749-0010000 Attachment, 24 x 26 mm 07746-0010700 Oil Seal Driver Attachment, 96 mm 07ZAD-PNAA100 1. M/T model: Install the crankshaft end bushing ...

    See also:

    Circuit Diagram
    ...

    VTEC Rocker Arm Test
    Special Tools Required . VTEC Air Stopper 07ZAJ-PNAA200 . VTEC Air Adapter 07ZAJ-PNAA101 (2) . Air Joint Adapter 07ZAJ-PNAA300 - Air Pressure Regulator 07AAJ-PNAA101 1. Start the engine, and let ...

    Sealing Bolt Installation
    NOTE: When installing the sealing bolt, always use a new washer. ...