Honda Accord: Outside Air Temperature Sensor Test
1 Remove the outside air temperature sensor (see page 22-353).
2. Dip the sensor in ice water, and measure the resistance. Then pour warm water on the sensor, and check for a change in resistance.
3. Compare the resistance reading between terminals No, 1 and No. 2 of the outside air temperature sensor with the specifications shown in the graph; the resistance should be within the specifications.
OUTSIDE AIR TEMPERATURE SENSOR
TEMPERATURE
4. If the resistance is not as specified, replace the outside air temperature sensor (see page 22-353).
Outside Air Temperature indicator
Calibration
NOTE: To test the outside air temperature sensor (see
page 21-185).
Description
The outside air temperature sensor is located behind the
center of the front bumper. The gauge control module
uses ...
Outside Air Temperature Sensor
Replacement
1 Disconnect the 2P connector (A) from the outside air
temperature sensor (B).
2. Lift the tab (C) to release the lock, then remove the
outside air temperature sensor from the front
bumper.
3 ...
See also:
Inboard Joint Side
1. Wrap the splines with on the driveshaft vinyl tape (A)
to prevent damaging the inboard boot.
2. Install the inboard boot onto the driveshaft, then
remove the vinyl tape. Be careful not to dama ...
Resetting the Moonroof Control Unit
Resetting the moonroof is required when any of the following have occurred:
• The moonroof was moved manually while the battery was dead or disconnected.
• The moonroof motor was replace ...
Exterior Care
Dust off the vehicle body after you drive.
Regularly inspect your vehicle for scratches on painted surfaces. A scratch on a
painted surface can result in body rust. If you find a scratch, promptly ...