Accessory Power Sockets

Circuit Diagram

See also:

Clutch Pedal Position Switch Test
M/T model 1. Disconnect the clutch pedal position switch 3P connector (A). 2. Remove the clutch pedal position switch (B). 3. Check for continuity between the terminals according to the table ...

WiperA/Vasher Switch Test / Replacemen
1. Remove the steering column covers {see page 20-181). 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the ...

Stabilizer Bar Replacement
Special Tools Required - Engine Hanger Adapter VSB02C000015* - Engine Support Hanger, A and Reds AAR-T1256* -Subframe Adapter VSB02C000016* - Subframe Alignment Pin 070AG-SJAA10S *: Available thr ...