Passenger's Under-dash Fuse/Relay Box (MICU) Removal and Installation

NOTE: SRS components are located in this area. Review the SRS component locations 4-door (see page 24-21), 2-door (see page 24-23), and precautions, and procedures (see page 24-25) before doing rep ...

Battery Test

A battery can explode if you do not follow the proper procedure, causing seiious injury to anyone nearby. Follow all procedures carefully and keep sparks and open flames away from the battery. R ...

See also:

Shifting
Change the shift position in accordance with your driving needs. • Shift lever positions You cannot turn the ignition switch to LOCK and remove the key unless the shift lever is in . The ...

Secondary H02S Replacement
Special Tools Required 02 Sensor Wrench Snap-on S6176 or equivalent, commercially available 1. Disconnect the secondary H02S 4P connector (A), then remove the secondary H02S (B). 2. Install the ...

Stabilizer Link Removal/Installation
1. Raise and support the vehicle (see page 1 -13). 2. Remove the rear wheel. 3. Remove the flange nut (A) and the self-locking nut (B) while holding the respective joint pin (C) with a hex wre ...