Honda Accord: Backlash Inspection
1. Place the differential assembly on V-blocks (A), and install the intermediate shaft (B) and the left driveshaft (C).

2. Measure the backlash of both pinion gears (D) with a dial indicator (E). If the backlash is not within the standard, check the differential carrier condition, and replace it if necessary.
Standard (New): 0.05-”0.15 mm
(0.002-0.006 in)
Differential Carrier/Final Driven Gear Replacemen
1. Loosen the bolts in a crisscross pattern in several
steps, then remove the bolts and the final driven gear
(A) from the differential carrier (B).
2. Install the final driven gear with the cham ...
See also:
Ceiling Light
The ceiling light has a three-position
switch: ON, Door Activated, and
OFF. In the Door Activated (center)
position, the light comes on when
you:
Open either door.
Unlock the driver’s do ...
Cam Chain Installation
Special Tools Required
Camshaft Lock Pin Set 07AAB-RWCA120
NOTE:
- Keep the cam chain away from magnetic fields.
- Before doing this procedure, check that the variable
valve timing control (VTC ...
System Description
SRS Components
Airbags
The SRS is a safety device which, when used with the seat belt, is designed
to help protect the driver and front
passenger in a frontal impact exceeding a certain set limit ...
