Shift Cable Adjustment

1. Remove the center console (see page 20-158). 2. Move the shift lever to R. 3. Remove the nut securing the shift cable end. 4. Unlock the retainer (A). 5. Rotate the socket holder retain ...

Component Location Index

...

See also:

Ignition Key Switch Test
1. Remove the steering column upper and lower covers (see page 20-181). 2. Disconnect the 6P connector (A). 3. Check for continuity between terminals No. 1 and No. 2. • There should ...

Piston Installation
If the Crankshaft is Already Installed 1. Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. 2. Remove the connecting rod caps, then install the ring co ...

Selector Centre! Sheft Bearing Replacement
Special Tools Required •Driver Handle, 15 x 135L 07749-0010000 -Attachment, 22 x 24 mm 07746-001A800 1. Remove the oil seal from the end cover, then remove the bearing. 2. Install a new be ...