A/T Gear Position indicator

Circuit Diagram

See also:

Electrical Compass Zone Selection and Calibration
NOTE: • You should do this procedure any time the electrical compass unit is replaced. • You should do this procedure in an open area away from buildings, power lines, and other vehicl ...

A/T Clutch Pressure Control Solenoid Valve A Test
1. Connect the HDS to the DLC (A) located under the driver's side of the dashboard. 2. Turn the ignition switch to ON (II). Make sure the HDS communicates with the PCM. If it does not, go to the ...

System Diagnostic Mode
Start-up procedure and Diagnostic IVieny There are two ways t o enter the diagnostic mode: Method 1 : Start the vehicle. When the globe screen appears, connect the SCS service connector (see page ...