Component Location Index

...

Glass Position Adjustment

The roof panel (A) should be even with the glass weatherstrip (B), to within 0+1/— 1 mm (0+0.04/—0.04 in) all the way around. If not make the following adjustment: 1. Remove the brac ...

See also:

Driveshaft Inspection
1. Check the inboard boot (A) and the outboard boot (B) on the driveshaft (C) for cracks, damage, leaking grease, and loose boot bands (D). If any damage is found, replace the boot and the boot ban ...

Sealing Bolt Installation
NOTE: When installing the sealing bolt (A), always use a new washer. ...

Door Position Adjustment
NOTE: Check for a flush fit with the body, then check for equal gaps between the front, rear, and bottom door edges and the body. Check that the door and body edges are parallel. 1. Place the ve ...