Hazard Warning Switch Test/Replacement

1. Remove these items: • Center vent for w i t h navigation system (see page 20-178) • Audio unit for without navigation system (see page 23-115) 2. Remove the hazard warning switch (A) ...

Component Location Index

4-door 2-door ...

See also:

Park Lever Stop Inspection and Adjustment
1. Set the park lever in the P position. 2. Measure the distance (A) between the park pawl shaft (B) and the park lever roller pin (C). Standard: 57.7-58.7 mm (2.27-2.31 in) 3. If the measurem ...

APP Sensor Signal I n s p e c t i o n
NOTE: - This procedure checks the APP sensor in its fully closed position. In any other position, the APP sensor stores DTCs which are covered in other troubleshooting procedures. - Check for P ...

Symptom Troubleshooting
VSA activation indicator does not go off, and no DTCs are stored NOTE: If the VSA modulator was replaced prior to the activation indicator turning on, do the VSA sensor neutral position memorizati ...