Honda Accord: Electronic Throttle Control System
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Fuel and Emissions / Electronic Throttle Control System
- Component Location Index
- DTC Troubleshooting
- APP Sensor Signal I n s p e c t i o n
- Accelerator Pedal Module Removal/Installation
ECM/PCM Replacement
Special Tools Required
- Honda diagnostic system (HDS) tablet tester
- Honda Interface Module (HIM) and an iN workstation
with the latest HDS software version
- HDS pocket tester ...
See also:
DTC Troubleshooting
DTC P0443: EVAP Canister Purge Valve Circuit
Malfunction
Special Tools Required
Vacuum Pump/Gauge, 0 - 3 0 In.Hg, Snap-on YA4000A
or equivalent commercially available
NOTE: Before you troubleshoo ...
Lower Arm B Replacement
1 Raise and support the vehicle (see page 1-13).
2. Remove the rear wheel.
3. Remove the lower arm B mounting bolts, then
remove lower arm B.
NOTE: Use new mounting bolts during reassembly.
...
Cylinder Head Installation
1. Install a new coolant separator (A) In the engine block
whenever the engine block is replaced.
2. Clean the cylinder head and the engine block surface.
3. Install the new cylinder head gaske ...