Honda Accord: Mode Control Motor Replacement
1. Remove the blower unit (see page 21-65).
2. Disconnect the 7P connector (A) from the mode control motor (B). Remove the self-tapping screws and the mode control motor from the heater unit.
3. Install the motor in the reverse order of removal.
Make sure the pin on the motor is properly engaged with the linkage. After installation, make sure the motor runs smoothly.
Mode Control Motor Test
'08-09 models with A/T and '10 model
with A/T
NOTE; Before testing the motor, check for HVAC DTCs
(see page 21-9).
1. Disconnect the 7P connector from the mode control
motor.
Incorrectly app ...
Recirculation Control Motor Test
'08-09 models 4-door with A/T and "10 model
with A/T
NOTE: Before testing the motor, check for HVAC DTCs
(see page 21-9).
1. Disconnect the 7P connector from the recirculation
control moto ...
See also:
Valve Stem-to-Guide Clearance
Inspection
1. Remove the valves (see page 6-86).
2. Subtract the O.D. of the valve stem, measured with a
micrometer, from the I.D. of the valve guide,
measured with an inside micrometer or a ball gauge.
...
Symptom Troubleshooting
Index
...
Towing a Trailer
Your vehicle has been designed
primarily to carry passengers and
their cargo. You can also use it to
tow a trailer if you carefully observe
the load limits, use the proper
equipment, and fol ...