Intermediate Shaft Installation

1. Clean the areas where the Intermediate shaft contacts the differential thoroughly with solvent, and dry then with compressed air. NOTE: Do not wash the rubber parts with solvent. 2. Install ...

How to Use This Manual

This manual is divided into multiple sections.The first page of each section is marked with a black tab that lines up with its corresponding thumb index tab on this page and the back cover. You c ...

See also:

Active Noise Cancellation Microphone Removal/Installation
Front 1. Remove the roof console (see page 20-140), and disconnect the connector (A) from the front active noise cancellation microphone (B). 2. Remove the screws and the front active noise can ...

ATF Pump Inspection
1. Install the ATF pump drive gear (A), the driven gear (B), and the ATF pump driven gear shaft (C) in the main valve body (D). Lubricate all parts with ATF, and install the ATF pump driven gear wi ...

Trim Removal/Installation Door Areas
Special Tools Required KTC Trim Tool Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 Door Sill Area - 2-door NOTE: - Put on gloves to protect your ha ...