Safe Driving

Controls

See also:

DTC Troubleshooting
DTC P0506: idle Control System RPM Lower Than Expected NOTE: Before you troubleshoot record all freeze data and any on-board snapshot, and review the general troubleshooting information (see page ...

Mainshaft 5th Gear Axial Clearance Inspection
1. Remove the mainshaft transmission housing bearing (seepage 14-270). 2. Install the thrust needle bearing ( A ) , 5th gear ( B ) , the needle bearing (C), the thrust needle bearing (D), the 41 ...

Inboard Joint Side
1. Wrap the splines with on the driveshaft vinyl tape (A) to prevent damaging the inboard boot. 2. Install the inboard boot onto the driveshaft, then remove the vinyl tape. Be careful not to dama ...