Eco Assist System

Instrument Panel

See also:

Outboard Joint Side
1. Wrap the splines on the driveshaft with vinyl tape (A) to prevent damaging the outboard boot. 2. Install new ear clamp bands (B) and the outboard boot onto the driveshaft, then remove the viny ...

Rewriting the ODO Data and Transferring the Maintenance Minder Data to a New Gauge Control Module
NOTE: • Obtain a new gauge control module before starting the rewriting process. Only new gauges can be rewritten. • Rewriting is not possible on a gauge control module that will not ...

Driver's Under-dash Fuse/Relay Box (MICU) Removal and Installation
Special Tools Required Relay Puller 07AAC-000A1A0 USA models NOTE; SRS components are located in this area. Review the SRS component locations 4-door (see page 24-21), 2-door (see page 24-23), an ...