Starter Overhaul

Disassembly/Reassembly Armature Inspection and Test 1. Remove the starter (see page 4-11). 2. Disassemble the starter as shown in the Exploded View. 3. Inspect the armature for wear or dama ...

Component Location Index

...

See also:

Checking the Engine
If the engine does not start, check the starter. If you must start the vehicle immediately, use an assisting vehicle to jump start it. ...

Clutch Clearance Inspection
Special Tools Required Clutch Compressor Attachment 07ZAE-PRP0100 1. Inspect the clutch piston, the clutch discs, the clutch plates, and the clutch end-plate for wear and damage (see page 14-303), ...

Reverse Shift Fork Clearance Inspection
1. Measure the clearance between the reverse Idler gear (A) and the reverse shift fork (B) with a feeler gauge (C). If the clearance exceeds the service limit, go to step 2. Standard; 0.20-0.59 mm ...