Honda Accord: High Mount Brake Light Replacement
1. Open the trunk lid.
2. Disconnect the 2P connector (A) from the high mount brake light.
High Mount Brake Light: 21 W
3. Turn the bulb socket (B) 45 В° counterclockwise to remove the bulb (C).
4. Remove the rear shelf (see page 20-128).
5. Remove the high mount brake light (A).
6. Install the light in the reverse order of removal.
License Plate Light Replacement
4-door
1. Poll the license plate light assembly out, and
disconnect the 2P connector (A) from the license plate
light.
License Plate Light: 5W
2. Separate the lens (B) and housing (C), then rem ...
Brake Pedal Position Switch Test
1. Disconnect the 4P connector (A) from the brake pedal
position switch (B).
2. Check for continuity between terminals No. 1 and No.
2.
• There should be continuity when the brake pedal ...
See also:
Transmission End Cover
End Cover Installation
Exploded View
Special Tools Required
Mainshaft Holder 07GAB-PF50101
NOTE: Refer to the Exploded View as needed during the
following procedure.
1. Install the mainshaft ...
A/C Condenser Fan Circuit
Troubleshooting
NOTE:
• Do not use this troubleshooting procedure if the
radiator fan and/or the A/C compressor is inoperative.
Refer to the symptom troubleshooting index.
• Before doing symptom tro ...
Circuit Diagram
...