Honda Accord: Front Seat Slide Lever Replacement
Driver's seat (manual height adjustable seat)/passenger's seat
NOTE: - Put on gloves to protect your hands.
- Take care not to tear or damage the seat covers.
1. Remove the front seat {see page 20-194).
2. Lift up the front seat, and pull out the slide lever (A) while prying up the spring (B) f r om the lever holders (C) of both seat tracks, then remove the lever.
3. Install the slide lever by pushing on it into the lever holders of both seat tracks until the springs snap the slits in the lever.
4. Apply multipurpose grease to the pivot areas of the slide locks.
Front Seat Slide Motor Replacement
SRS components are located in this area. Review the
SRS component locations, 2-door (see page 24-23),
4-door (see page 24-21) and the precautions and
procedures (see page 24-25) before doing repair ...
Front Seat Torsion Bar Replacement
2-door Driver's seat (manual height
adjustable seat)
NOTE:
- Put on gloves to protect your hands.
- Take care not to tear or damage the seat covers.
- When prying with a flat-tip screwdriver, ...
See also:
Charging System Indicator
Charging System
Indicator
If the charging system indicator
comes on brightly when the engine
is running, the battery is not being
charged.
Immediately turn off all electrical
accessories ...
General Troubleshooting Information
System Indicator
The TPMS (tire pressure monitoring system) has the low
tire pressure indicator and the TPMS indicator.
The Low Tire Pressure Indicator
- If the system detects low pressure in an ...