Engine Electrical

Cylinder Head

See also:

Training HomeLink
Before you begin - If you just received your vehicle and have not trained any of the buttons in HomeLink before, you should erase any previously learned codes before training the first butto ...

Secondary Shaft 2nd Gear Axial Clearance Inspection
1. Install the thrust needle bearing (A), the needle bearing (B), 2nd gear (C), the thrust needle bearing (D), the 37 x 58 mm thrust washer (E), and the 2nd clutch (F) on the secondary shaft (G), t ...

Brake Pedal Position Switch Test
1. Disconnect the 4P connector (A) from the brake pedal position switch (B). 2. Check for continuity between terminals No. 1 and No. 2. • There should be continuity when the brake pedal ...