Honda Accord: Driving Position Memory System - Instruments and Controls - Honda Accord 2008-2012 Owner's ManualHonda Accord: Driving Position Memory System

U.S. V6 models, and Canadian EX-L and V6 models with navigation system

Your vehicle has a memory feature for the driver’s seat position.

Seat, except for power lumbar, position can be stored in separate memories. You select a memorized position by pushing the appropriate button or using the appropriate remote transmitter (Driver 1 or Driver 2).

Seat Heaters
EX-L and all V6 models Both front seats are equipped with seat heaters. Because of the sensors for the side airbag cutoff system, there is no heater in the passenger’s seat-back. The igni ...

Storing a Driving Position in Memory
Store a driving position only when the vehicle is parked. 1. Turn the ignition switch to the ON (II) position. You cannot add a new driving position to the memory unless the ignition switch ...

See also:

Center Pocket Removal/Installation
Without Navigation System NOTE; - Take care not to scratch the dashboard or the related parts. - A/T is shown; M/T is similar. 1. Remove the center console panel (see page 20-157). 2. A/T: ...

Steering Angle Sensor Replacement
SRS components are located In this area. Review the SRS component locations: 4-door (see page 24-21), 2-door (see page 24-23) and the precautions and procedures (see page 24-25). NOTE: Do not da ...

Intermediate Shaft Removal
1. Drain the transmission fluid. Reinstall the drain plug using a new sealing washer: -Manual transmission (see page 13-5) -Automatic transmission (see page 14-192) 2. Remove the right driveshaft ...