Honda Accord: Circuit Diagram
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Engine Electrical / Cruise Control / Circuit Diagram

Cruise Control Input Test
NOTE: Always make sure that you have the latest Honda Diagnostic System (HDS)
software.
1. Connect the HDS to the data link connector (DLC) (see step 2 on page 11 -3).
2. Turn the ignition swi ...
See also:
XM Receiver Removal/Installation
1. Open the trunk lid, and remove the right trunk side
trim panel {see page 20-132).
2. Disconnect the connectors (A) from the XM receiver
(B).
4-Door
3. Remove the mounting bolt (C) and lo ...
Under-floorTWC Removal/Installation
1. Raise the vehicle on a lift.
2. Remove the exhaust pipe hangers (A).
3. Remove the under-floor TWC (B).
4. Install the parts in the reverse order of removal with
new gaskets (C) and new s ...
Switch Test/Replacement
1. Remove the center console panel (see page 20-157).
2. Disconnect the 6P (or 7P*) connector from the seat
heater switch, then remove the switch.
*: Front passenger's seat heater switch
3. ...
