Component Location Index

  ...

DTC Troubleshooting

DTC B1077: Windshield Wiper Auto-stop (AS) Signal Circuit Malfunction NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see ...

See also:

Cleaning the Seat Belts
If your seat belts get dirty, use a soft brush with a mixture of mild soap and warm water to clean them. Do not use bleach, dye, or cleaning solvents. Let the belts air dry before you use ...

CMP Sensor B Replacement
1. Disconnect the connector (A) and hoses (B) from the EVAP canister purge valve (C), then remove the EVAP canister purge valve assembly. 2. Disconnect the CMP sensor B connector (A). 3. Remov ...

Upper Arm Replacement
Special Tools Required - Ball Joint Thread Protector, 14 mm 07AAE-SJAA100 * Ball Joint Remover, 32 mm 07MAC-SL0A102 1. Raise and support the vehicle (see page 1-13). 2. Remove the rear wheel. ...