Honda Accord: Blower Unit Component Replacement - Heating/Air Conditioning - Heating, Ventilation, and Air Conditioning - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Blower Unit Component Replacement

Note these items when overhauling the blower unit: • The recirculation control motor (A), the blower motor (B), and the dust and pollen filter (C) can be replaced without removing the blower unit.

• Before reassembly, make sure that the recirculation control linkage and door move smoothly without binding.

• After reassembly, make sure the recirculation control motor runs smoothly (see page 21-64).

Evaporator Core Replacement


    Blower Unit Removal/Installation
    1. Remove the glove box (see page 20-174). 2. Remove the passenger's undercover (see page 20-170). 3. Remove the right kick panel (see page 20-107). 4. Remove the dust and pollen filter asse ...

    Evaporator Core Replacement
    1. Recover the refrigerant with a recovery/recycIing/charging station (see page 21-80). 2. Remove the bolt from the A/C line clamp (A). 3. Remove the bolt, then disconnect the A/C line (A) fro ...

    See also:

    Resetting the Engine Oil Life Display
    Your dealer will reset the display after completing the required maintenance service. You will see ‘‘OIL LIFE 100%’’ on the information display the next time you turn the ignition sw ...

    ODS Unit Operation Check
    Check the ODS operation after any of these actions: • Replacement of front passenger's seat component(s) (except ODS unit and/or weight sensors) • After a vehicle collision • SRS un ...

    Stabilizer Link Removal/Installation
    1. Raise and support the vehicle (see page 1 -13). 2. Remove the front wheel. 3. Remove the self-locking nut (A) and the flange nut (B) while holding the respective joint pin (C) with a hex wr ...