Power Mirror Actuator Replacement

Removal 1. Remove the mirror holder (see page 20-63). 2. Remove the power mirror (see page 20-62), and disconnect the power mirror 8P connector from the door wire harness. 3. Remove the gaske ...

Circuit Diagram

...

See also:

Park Lever Stop Inspection and Adjustment
1. Set the park lever in the P position. 2. Measure the distance (A) between the park pawl shaft (B) and the park lever roller pin (C). Standard: 57.7-58.7 mm (2.27-2.31 in) 3. If the measurem ...

Checking the Engine
If the engine does not start, check the starter. If you must start the vehicle immediately, use an assisting vehicle to jump start it. ...

Drive Belt Inspection
1. Inspect the belt for cracks or damage. If the belt is cracked or damaged, replace it (see page 4-30). 2. Check the position of the auto-tensioner indicator's pointer (A) is within the standard ...