Honda Accord: Track Scan
When you press the SCAN side of the SCAN/A. SEL bar or scroll down and push the interface selector to the left, the next track of the current track plays for about 10 seconds.
You will see SCAN next to TRACK on the screen and center display. To listen to the rest of the track, press and hold the SCANside of the bar until you hear a beep or push the interface selector to the left again within 10 seconds.
If you don’t, the system advances to the next track, plays about 10 seconds of it, and continues through the rest of the tracks the same way.
To Choose a Track
You can also choose a track directly
from a track list. Press ENTER on
the interface selector, and the track
list screen will be shown. If there are
no track names, track numbers are
displ ...
Disc Scan
When you press the SCAN side of
the SCAN/A. SEL bar repeatedly
until you see D-SCAN in the center
display, or push the interface
selector to the right, the first track of
the current disc pl ...
See also:
Connector to Harness Index
Starter Subharness
Engine Wire Harness (M/T)
Engine Wire Harness ( A / T )
*1: PZEV
*2: Except PZEV
CKP Sensor Subharness
Shift Solenoid Wire Harness (A/T)
Transmission Rang ...
Audio Unit Removal/Installation
With Navigation
SRS components are located in this area. Review the
SRS component locations (see page 24-23), and the
precautions and procedures (see page 24-25) before
doing repairs or service.
...
Replacing Rear Bulbs
1. Open the trunk.
Remove the screws in the center
of each of the two fasteners on the
side of the trunk lining. Pull the
lining back.
2. Determine which of the three
bulbs is burned out: ...