Honda Accord: To Play the Radio - Audio System - Features - Honda Accord 2008-2012 Owner's ManualHonda Accord: To Play the Radio

The band and frequency that the radio was last tuned to are displayed.

To change bands, press the AM or FM button. On the FM band, ST will be displayed if the station is broadcasting in stereo. Stereo reproduction in AM is not available.

On the AM band, AM noise reduction turns on automatically.

The ignition switch must be in the ACCESSORY (I) or ON (II) position.

Turn the system on by pushing the power/volume knob or the AM or FM button. Adjust the volume by turning the power/volume knob.

    Playing the FM/AM Radio (Models without navigation system)
    Playing the FM/AM Radio (Models without navigation system) ...

    To Select a Station
    You can use any of five methods to find radio stations on the selected band: tune, skip, scan, the preset buttons, and auto select. On the FM band, you can also use the features provided by t ...

    See also:

    HVAC Control Power and Ground Circuit Troubleshooting
    1. Check the No. 16 (7.5 A) fuse in the driver's under-dash fuse/ relay box. Is the fuse OK? YES-Go to step 2. NO-Replace the fuse, and recheck. If the fuse blows again, check for a short in ...

    Audio Unit Removal/Installation
    With Navigation SRS components are located in this area. Review the SRS component locations (see page 24-23), and the precautions and procedures (see page 24-25) before doing repairs or service. ...

    Mainshaft Bearing and Oil Seal Replacement
    Special Tools Required - Oil Seal Driver, 65 07JAD-PL90100 - Adjustable Bearing Puller, 20-”40 mm 07736-A01000B - Bearing Driver Attachment, 42 x 47 07746-0010300 - Driver Handle, 15 x 135L ...