Honda Accord: System Setup
This command group allows you to change or customize HFL basic settings.
To set a 4-digit passcode to lock the HFL system for security purposes:
Press and release the HFL Talk button before a command.
1. Say ‘‘System setup.’’ 2. Say ‘‘Security’’ after the prompts.
3. Follow the HFL prompts and say the 4-digit passcode you want to set.
4. Follow the HFL prompts to confirm the number.
NOTE: Once a passcode is set, you will need to enter it to use HFL each time you start the vehicle. If you forget the code, your dealer will have to reset it for you, or youwill have to clear the entire system.
PIN Number
You can add, change, or remove a
PIN number from any phonebook.
To add a PIN:
If you have selected a phonebook
without a PIN, you will see the above
display.
Enter the new 4-digit PIN. You ...
Before Driving
Before you begin driving your
vehicle, you should know what
gasoline to use and how to check the
levels of important fluids. You also
need to know how to properly store
luggage or packages. ...
See also:
Cf Hinder Bore Honing
Only a scored or scratched cylinder bore must be honed.
1. Measure the cylinder bores (see page 7-17).
If the engine block is to be reused, hone the cylinders,
and remeasure the bores.
2. Re ...
Door Key Cylinder Switch Test
1. Remove the driver's door panel (see page 20-17).
2. Disconnect the 10P connector (A) from the door lock
actuator (key cylinder switch) (B).
3. Check for continuity between the terminals.
...
Output Shaft (Countershaft) Speed
Sensor Replacement
1. Remove the nut securing the under-hood fuse/relay
box, and swing it out of the way.
2. Remove the intake air duct and the air cleaner
housing.
3. Disconnect the output shaft (countershaft) ...