Test/Replacement

EX-L, EX-L PZEV models 1. Remove the cover (A), then disconnect BP connector (B). 2. Turn the ignition switch to ON (II). 3. Measure the voltage between terminal No. 2 and body ground. вР...

Component Location Index

...

See also:

Storing a Driving Position in Memory
Store a driving position only when the vehicle is parked. 1. Turn the ignition switch to the ON (II) position. You cannot add a new driving position to the memory unless the ignition switch ...

EVAP Canister Replacement
1. Raise the vehicle on a lift. 2. Remove the wheel sensor harness clamps (A) 3. Support the rear subframe with a transmission jack and a wooden block as shown. 4. Remove the rear subframe m ...

Maintenance
This chapter discusses basic maintenance. ...