Safety Labels

Label Locations These labels are in the locations shown. They warn you of potential hazards that can cause serious injury or death. Read these labels carefully. If a label comes off or becomes h ...

Indicators

...

See also:

Electrical Compass Zone Selection and Calibration
NOTE: • You should do this procedure any time the electrical compass unit is replaced. • You should do this procedure in an open area away from buildings, power lines, and other vehicl ...

Pre-Tow Checklist
When preparing to tow, and before driving away, be sure to check the following: The vehicle has been properly serviced, and the suspension and the cooling system are in good operating condi ...

Valve Stem-to-Guide Clearance Inspection
1. Remove the valves (see page 6-86). 2. Subtract the O.D. of the valve stem, measured with a micrometer, from the I.D. of the valve guide, measured with an inside micrometer or a ball gauge. ...