General Troubleshooting Information

Mow to Check for DTCs with the HDS NOTE: Check the vehicle battery condition first {see page 22-90). 1. Make sure the ignition switch is turned to LOCK (0). 2. Connect the HDS to the data link ...

Symptom Troubleshooting Index

...

See also:

Wheel Runout Inspection
1. Raise and support the vehicle (see page 1 -13). 2. Check for a bent or deformed wheel. 3. Set up the dial gauge as shown, and measure the axial runout by turning the wheel. Front and rear w ...

Driveshaft Disassembly
Special'Tools Required •Threaded Adapter, 26 x 1.5 mm 07XAC-001030A -Slide Hammer 5/8M-18 UNF, commercially available -Bearing Puller, commercially available -Boot Band Pliers, commercially ...

Trunk Lid Latch Replacement
Special Tools Required KTC Trim Too! Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: - Put on gloves to protect your hands. - Take care not t ...