Maintenance Minder

The information display in the instrument panel shows you the engine oil life and maintenance service items when the ignition switch is in the ON (II) position. This information helps to kee ...

Windshield Wipers andWashers

Windshield Wipers 1. MIST 2. OFF 3. INT - Intermittent 4. LO - Low speed 5. HI - High speed 6. Windshield washers Push the right lever up or down to select a position. MIST - The wipe ...

See also:

Housing and Shaft Assembly Removal
Special Tools Required Housing Puller 07HAC-PK40102 1. Remove the ATF feed pipe (A) from the idler gear shaft, and remove the ATF lubrication pipe (B) from the transmission housing. 2. Remove ...

Cf Hinder Bore Honing
Only a scored or scratched cylinder bore must be honed. 1. Measure the cylinder bores (see page 7-17). If the engine block is to be reused, hone the cylinders, and remeasure the bores. 2. Re ...

VSA Sensor Neutral Position Memorization
NOTE: Do not press the brake pedal during this procedure. 1. Park the vehicle on a flat and level surface, with the steering wheel in the straight ahead position. 2. With the ignition switch i ...