HandsFreeLink System

...

General Troubleshooting Information

Mow to Check for DTCs with the HDS NOTE: Check the vehicle battery condition first {see page 22-90). 1. Make sure the ignition switch is turned to LOCK (0). 2. Connect the HDS to the data link ...

See also:

Power Mirror Actuator Replacement
Removal 1. Remove the mirror holder (see page 20-63). 2. Remove the power mirror (see page 20-62), and disconnect the power mirror 8P connector from the door wire harness. 3. Remove the gaske ...

Trunk Lid Cushion Replacement
1. Remove the trunk lid cushion (A) by pulling it out to detach the clips. 2. Replace the trunk lid cushion with a new one. 3. Install the trunk lid cushion by pushing on the clip areas until ...

Countershaft Bearing Replacement
Special Tools Required - Oil Seal Driver, 65 07JAD-PL90100 - Adjustable Bearing Puller, 20-”40 mm 07736-A01000B - Slide Hammer 3/8"-16 UNF, commercially available 1. Remove the bearing ...