Honda Accord: Trunk Lid Dynamic Damper Replacement - Trunk Lid - Body - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Trunk Lid Dynamic Damper Replacement

2-door

NOTE: Take care not to scratch the trunk lid.

1. Remove the cover (A) by releasing the hooks (B).

Remove the bolts, and detach the clips, then remove the trunk lid dynamic damper bracket (C) with the trunk lid dynamic damper.

2. Install the damper in the reverse order of removal,


2. Install the damper in the reverse order of removal, and note these items: - If the clips are damaged or stress-whitened, replace them with new ones.

- Push the clips and the hooks into place securely.

4-door

NOTE: Take care not to scratch the trunk lid.

1. Remove the cover (A) by releasing the hooks (B).

Remove the bolts (C), then remove the trunk lid dynamic damper (D).

2. Install the damper in the reverse order of removal,


2. Install the damper in the reverse order of removal, and push the hooks into place securely.

    Trunk Lid Cushion Replacement
    1. Remove the trunk lid cushion (A) by pulling it out to detach the clips. 2. Replace the trunk lid cushion with a new one. 3. Install the trunk lid cushion by pushing on the clip areas until ...

    Fuel Fill Door
    ...

    See also:

    Motor Test
    1. Remove the front seat back panel, and seat-back cover/pad. • 4-door (see page 20-221) • 2-door (see page 20-213) 2. Disconnect the 2P connector (A) from the lumbar support motor (B ...

    Secondary Shaft Disassembly, Inspection, and Reassembly
    1. Inspect the thrust needle bearings a n d the needle bearings for g a l l i n g and rough movement 2. Inspect the splines for excessive wear and damage. 3. Check the shaft bearing surface fo ...

    Front Seat Slide Motor Replacement
    SRS components are located in this area. Review the SRS component locations, 2-door (see page 24-23), 4-door (see page 24-21) and the precautions and procedures (see page 24-25) before doing repair ...