Trunk Lid Dynamic Damper Replacement

2-door NOTE: Take care not to scratch the trunk lid. 1. Remove the cover (A) by releasing the hooks (B). Remove the bolts, and detach the clips, then remove the trunk lid dynamic damper bracke ...

Fuel Fill Door Adjustment

1. Slightly loosen the hinge mounting bolts (A). 2 . Adjust the fuel fill door (B) in or out until it is flush with the body, and up or down as necessary to equalize the gaps. 3. Tighten the h ...

See also:

Ignition Coil and Spark Plug Removal/Installation
1. Remove the ignition coil cover (A). 2. Disconnect the ignition coil connectors (B), then remove the ignition coils (C). 3. Remove the spark plug and inspect them (see page 4-20). 4. Appl ...

Secondary Shaft 1 st Gear Axial Clearance Inspection
Special Tools Required Attachment, 42 mm I.D. 07QAD-P0A0100 1. Remove the secondary shaft transmission housing bearing (see page 14-270). 2. Install the thrust needle b e a r i n g (A), the need ...

Inboard Joint Side
1. Wrap the splines with on the driveshaft vinyl tape (A) to prevent damaging the inboard boot. 2. Install the inboard boot onto the driveshaft, then remove the vinyl tape. Be careful not to dama ...