Steering

Brakes

See also:

Stabilizer Link Removal/Installation
1. Raise and support the vehicle (see page 1 -13). 2. Remove the rear wheel. 3. Remove the flange nut (A) and the self-locking nut (B) while holding the respective joint pin (C) with a hex wre ...

A/C Pressure Switch Circuit Troubleshooting
NOTE: • if the blower motor does not run at all speeds, the A/C compressor will be inoperative. Run the self-diagnostic function, and check for DTC B1241. Before performing any other troubl ...

General Troubleshooting Information
Mow to Check for DTCs with the HDS NOTE: Check the vehicle battery condition first {see page 22-90). 1. Make sure the ignition switch is turned to LOCK (0). 2. Connect the HDS to the data link ...