Honda Accord: Removing Discs from the Changer
To remove the disc that is currently playing, press the eject button. You will see ‘‘EJECT’’ in the center display. When you remove the disc from the slot, the system automatically enters the previous mode AM, FM1, FM2, or XMRadio.
The system also begins the load sequence so you can load another disc. If you do not load another disc, the load sequence is canceled, and the system continues playing in the previous mode.
If you do not remove the disc from the slot, the system will reload the disc after 10 seconds. To begin playing the disc, press the CD button.
To remove a different disc from the changer, first select it by pressing the corresponding number on the preset button or turning the interface knob, and pressing ENTER on the interface selector. When that disc begins playing, press the eject button.
When you press the eject button while listening to the radio, or with the audio system turned off, the disc that was last selected is ejected.
After that disc is ejected, pressing the eject button again will eject the next disc in numerical order. By doing this six times, you can remove all the discs from the changer.
You can also eject discs when the ignition switch is off:
To eject one disc, press and release the eject button.
To eject all discs, press and hold the eject button until the first disc begins to eject.
Folder Random
This feature, when activated, plays
all files in the current folder in
random order. To activate folder
random play, select FOLDER
RANDOM by using the interface
knob, and press ENTER on the ...
Disc Changer Error Messages (Models with navigation system)
The chart on the right explains the
error messages you may see in the
center display while playing a disc.
If you see an error message in the
center display while playing a disc,
press the ej ...
See also:
Moonroof Control Unit input Test
NOTE; If the moonroof works OK manually, but will not work in AUTO, or
reverses frequently (obstacle detection), reset
the moonroof (see page 22-371) before proceeding with the input test
1. Turn ...
Front Brake Disc Inspection
Runout
1. Raise and support the vehicle (see page 1-13).
2. Remove the front wheels.
3. Remove the brake pads: NISSIN type (see page 19-14), AKEBONO type (see page
1947)
4. Inspect the bra ...
Wiper Motor Replacement
Removal
1. Open the hood. Remove the caps (A) and nuts (B).
NOTE: The illustration shows 4-door.
2. Close the hood, then spread protective cloths (A) on
the hood to avoid scratching the hood e ...