Honda Accord: Outside Air Temperature Sensor Replacement - Climate Control - Heating, Ventilation, and Air Conditioning - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Outside Air Temperature Sensor Replacement

1. Lift the tab (A) to release the lock, then remove the outside air temperature sensor (B) from the front bumper beam. Disconnect the 2P connector (C) from the outside air temperature sensor.

2. Install the sensor in the reverse order of removal.


2. Install the sensor in the reverse order of removal.

    Outside Air Temperature Sensor Test
    NOTE: Before testing the sensor, check for HVAC DTCs (see page 21-101):. 1. Remove the outside air temperature sensor (seepage' 21-185). 2. Dip the sensor in ice water, and measure the resist ...

    Sunlight Sensor Test
    N O T E ; Before testing t h e sensor, check for HVAC DTCs (see page 21-101). 1. Remove the sunlight sensor (see page 21 -186). With automatic lighting sensor Without automatic lighting sensor ...

    See also:

    Stabilizer Link Removal/Installation
    1. Raise and support the vehicle (see page 1 -13). 2. Remove the front wheel. 3. Remove the self-locking nut (A) and the flange nut (B) while holding the respective joint pin (C) with a hex wr ...

    Trunk Light Test/Replacement
    1. Open the trunk lid. 2. Carefully pry out the trunk light (A). Trunk Light: 5 W 3. Disconnect the 2P connector (B) from the trunk light. 4. Check for continuity between terminals No. 1 ( + ...

    Throttle Body Cleaning
    Do n o t i n s e r t : your fingers into the installed throve body when you turn the ignition switch to ON (II) or while the ignition switch is in ON (II). If you do, you will seriously injure your ...