Honda Accord: Multi-Information Display Warning andInformation Messages
The following messages appear only on the multi-information display. Press
the 
(information) button to see the
message again
with the system message indicator on.
Information Display Warning andInformation Messages
The following messages appear only on the information display.
...
See also:
Selector Centre! Sheft Bearing
Replacement
Special Tools Required
•Driver Handle, 15 x 135L 07749-0010000
-Attachment, 22 x 24 mm 07746-001A800
1. Remove the oil seal from the end cover, then remove
the bearing.
2. Install a new be ...
Outside Air Temperature indicator
Calibration
NOTE: To test the outside air temperature sensor (see
page 21-185).
Description
The outside air temperature sensor is located behind the
center of the front bumper. The gauge control module
uses ...
Cylinder Head Cover Installation
1. Thoroughly clean the head cover gasket and the
groove.
2. Install the head cover gasket (A) in the groove of the
cylinder head cover (B).
3. Check that the mating surfaces are clean and dry ...