Honda Accord: Instrument Panel Brightness - Instruments and Controls - Honda Accord 2008-2012 Owner's ManualHonda Accord: Instrument Panel Brightness

The select/reset knob on the

The select/reset knob on the instrument panel controls the brightness of the instrument panel lights. Turn the knob to adjust the brightness with the ignition switch in the ON (II) position and the parking lights on.

The level of brightness is shown on

The level of brightness is shown on the information display while you adjust it. It goes out about 5 seconds after you finish adjusting.

To reduce glare at night, the instrument panel illumination dims when you turn the light switch to . Turning the select/ or reset knob to the right until you hear. Turning the select/ reset knob to the right until you hear a beep will cancel the reduced brightness.

The instrument panel will illuminate with reduced brightness when you unlock and open the driver’s door.

The brightness will increase slightly when you insert the key in the ignition switch, then go to normal brightness when you turn the ignition switch to the ON (II) position.

If you do not insert the key in the ignition switch after opening the driver’s door, the illumination turns off about 30 seconds after you close the door.

If you insert the key but do not turn the ignition switch to the ON (II) position, the illumination turns off in about 10 seconds.

    Fog Lights
    If equipped Turn the fog lights on and off by turning the switch next to the headlight switch. You can use the fog lights only when the headlights are on low beam. With the light switch in ...

    HazardWarning Button
    Push the button between the center vents to turn on the hazard warning lights (four-way flashers). This causes all four outside turn signals and both turn indicators in the instrument pane ...

    See also:

    Seat Heater Test
    Driver's Seat 1. Remove the driver's seat (see page 20-194). 2. Remove the seat back panel. • 4-door (see page 20-221) • 2-door (see page 20-213) 3. Disconnect the connector A (4P) ...

    Evaporator Temperature Sensor Test
    NOTE: Before testing the sensor, check for HVAC DTCs (see page 2 1 - 9). 1. Remove the evaporator temperature sensor (see page 21-67). 2. Dip the sensor in ice water, and measure the resistan ...

    A/C Compressor Clutch Overhaul
    Special Tools Required • A/C Clutch Holder Robinair 10290 or Kent-Moore J37872, commercially available • A/C Clutch Holder Honda Tool and Equipment ACT499A, commercially available 1. Re ...