Honda Accord: Drive Plate Removal and Installation
1. Remove the transmission assembly (see page 14-194).
2. Remove the drive plate (A) and the washer (B) from the engine.
3. Install the drive plate and the washer on the engine, and tighten the eight bolts in a crisscross pattern in at least two steps.
4. Install the transmission assembly (see page 14-205).
Transmission Removal
Special Tools Required
-Engine Hanger Adapter VSB02C000015*
-Engine Support Hanger, A and Reds AAR-T1256*
- Subframe Adapter VSB02C000016*
*: Available through the Honda Tool and Equipment
Progra ...
Transmission Installation
Special Tools Required
-Engine Hanger Adapter VSB02C000015*
•Engine Support Hanger, A and Reds
AAR-T1256*
-Subframe Adapter VSB02C000016
-Subframe Alignment Pin 070AG-SJAA10S
*: Available ...
See also:
Wheel Runout Inspection
1. Raise and support the vehicle (see page 1 -13).
2. Check for a bent or deformed wheel.
3. Set up the dial gauge as shown, and measure the
axial runout by turning the wheel.
Front and rear w ...
Symptom Troubleshooting
Information
General Check Before Troubleshooting
Before troubleshooting the immobilizer system, check the following general
items and solve any if applicable:
• The battery is low; charge the battery ful ...
Driver's Power Window Motor Test
Motor Test
1. Remove the power window master switch.
• 4-door (see page 22-305)
• 2-door (see page 22-306)
2. Test the motor in each direction by connecting battery
power and ground t ...