Engine Lubrication

Fuel and Emissions

See also:

Alternator Control Circuit Troubleshooting
NOTE: Do this troubleshooting if, in step 5 of the alternator and regulator circuit troubleshooting (see page 4-27), the battery voltage is less than 13.5 V. * 1. Connect the Honda Diagnostic Sys ...

Intermediate Shaft Disassembly
Special Tools Required •Half Shaft Base 07NAF-SR30101 -Oil Seal Driver, 44.5 mm 07947-SB00100 1. Remove the heat shield (A). 3. Press the intermediate shaft (A) out of the intermediate s ...

A/C Signal Circuit Troubleshooting
1. Start the engine, and let it idle. 2. Turn the blower switch on. 3. Turn the A/C switch on. 4. Check the A/C CLUTCH in the DATA LIST with the HDS. Does it indicate ON? YES-Go to step ...