Audio System

...

General Troubleshooting Information

Lever-Locked Connector Disconnecting To disconnect the connector, pull the lever (A) while pushing the lock tab (B) down, then pull the connector (C). Connecting To connect the connector, push ...

See also:

Mainshaft Thrust Clearance Adjustment
Special Tools Required - Mainshaft Holder 07GAJ-PG20110 - Mainshaft Base 07GAJ-PG20130 1. Remove the 72 mm shim (A) and oil guide plate M from the transmission housing (B). 2. Thoroughly clea ...

Stabilizer Link Removal/Installation
1. Raise and support the vehicle (see page 1 -13). 2. Remove the front wheel. 3. Remove the self-locking nut (A) and the flange nut (B) while holding the respective joint pin (C) with a hex wr ...

Door Glass Adjustment
NOTE: Check the door weatherstrip and the glass run channel for damage or deterioration, and replace them if necessary. 1. Place the vehicle on a firm, level surface when adjusting the door glas ...