A/T interlock System

Circuit Diagram

See also:

Test/Replacement
EX-L, EX-L PZEV models 1. Remove the cover (A), then disconnect BP connector (B). 2. Turn the ignition switch to ON (II). 3. Measure the voltage between terminal No. 2 and body ground. вР...

Secondary Shaft 2nd Gear Axial Clearance Inspection
1. Install the thrust needle bearing (A), the needle bearing (B), 2nd gear (C), the thrust needle bearing (D), the 37 x 58 mm thrust washer (E), and the 2nd clutch (F) on the secondary shaft (G), t ...

Lower Arm A Replacement
1. Raise and support the vehicle (see page 1-13). 2. Remove the rear wheel. 3. Remove the parking brake cable mounting bolt (B). 4. Remove the lower arm A mounting bolts, then remove lower a ...