HFL Menus

The power mode must be in ACCESSORY or ON to use HFL. • Phone Settings screen 1. Press the SETTINGS button. 2. Rotate to select Phone Settings, then press . To use HFL, you must first pa ...

Compass Calibration

If the compass indicates the wrong direction, or the CAL indicator blinks, you need to manually calibrate the system. Compass operation can be affected under the following conditions: • Driv ...

See also:

Audio Unit Removal/Installation
With Navigation SRS components are located in this area. Review the SRS component locations (see page 24-23), and the precautions and procedures (see page 24-25) before doing repairs or service. ...

Clutch Pedal Position Switch Replacement
M/T model 1 Disconnect the clutch pedal position switch connector (A). 2. Loosen the locknut (B), then remove the clutch pedal position switch (C). 3. Install the clutch pedal position switch ...

System Diagnostic Mode
Start-up procedure and Diagnostic IVieny There are two ways t o enter the diagnostic mode: Method 1 : Start the vehicle. When the globe screen appears, connect the SCS service connector (see page ...