Fuel and Emissions

Clutch (cont'd)

See also:

Motor Test
1. Remove the front seat back panel, and seat-back cover/pad. • 4-door (see page 20-221) • 2-door (see page 20-213) 2. Disconnect the 2P connector (A) from the lumbar support motor (B ...

Back-up Light Switch Test
1. Disconnect the back-up light switch 2P connector (A). 2. Check for continuity between back-up light switch 2P connector terminals No. 1 and No. 2. There should be continuity only when the shif ...

Status Log
If you suspect there is a immobilizer system problem, check the status log. 1. Connect the HDS to the data link connector. 2. Turn the ignition switch to ON (II). 3. On the HDS screen, at MAI ...