Engine Block

Component Location Index

See also:

Valve Seat Reconditioning
1. Inspect the valve stem-to-guide clearance (see page 6-88). If the valve guides are worn, replace them (see page 6-88) before cutting the valve seats. 2. Renew the valve seats in the cylinder h ...

Countershaft Inspection
1. Inspect the gear and bearing contact areas for wear and damage, then measure the countershaft at points A, B, and C. If any part of the countershaft is less than the service limit, replace it. ...

Mainshaft Thrust Clearance Adjustment
Special Tools Required - Mainshaft Holder 07GAJ-PG20110 - Mainshaft Base 07GAJ-PG20130 1. Remove the 72 mm shim (A) and oil guide plate M from the transmission housing (B). 2. Thoroughly clea ...