Honda Accord: Power Window Master Switch
Replacement
4-door
1. Carefully remove the power window master switch (A).
2. Disconnect the 37P connector (B) from the power window master switch, and the 13P connector (C) from the power mirror switch (D).
3. Remove the four screws and the power window master switch (A).
4. Install the switch in the reverse order of removal.
5. Reset the power window control unit (see page 22-280).
2-door
1. Remove the driver's door panel (see page 20-12).
2. Disconnect the 37P connector (A) from the power window master switch (B) and the 13P connector from the power mirror switch.
3. Remove the switch panel and armrest from the door panel (see page 20-12).
4. Remove the four screws and the power window master switch (A).
5. Install the switch in the reverse order of removal.
6. Reset the power window control unit (see page 22-280).
Rear Power Window Motor Test
1. Remove the rear power window switch (see page
22-307).
2. Test the motor in each direction by connecting battery
power and ground to the rear power window switch
14P connector (A) according t ...
Front Passenger's Power Window
Switch Replacement
4-door
1. Carefully remove the front passenger's power
window switch (A).
2. Disconnect the 37P connector (B) from the front
passenger's power window switch.
3. Remove the four screws and th ...
See also:
VTC Actuator, Exhaust Camshaft
Sprocket Replacement
Removal
1. Remove the cam chain (see page 6-62).
2. Hold the camshaft with an open-end wrench, then
loosen the variable valve timing control (VTC)
actuator mounting bolt and the exhaust camshaft ...
Component Replacement/Inspection After
Deployment
NOTE:
• Before doing any SRS repairs, check the DTCs (see
page 24-36) for the less o b v i o u s deployed
components (seat belt t e n s i o n e r s , front impact
sensors, side airbag sensors ...
Front Door Outer Molding
Replacement
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
NOTE:
- If you remove the door outer molding, replace it with a
...