Honda Accord: Owner’s Maintenance Checks - Maintenance Minder - Maintenance - Honda Accord 2008-2012 Owner's ManualHonda Accord: Owner’s Maintenance Checks

You should check the following items at the specified intervals. If you are unsure of how to perform any check, turn to the appropriate page listed.

Engine oil level Check every time you fill the fuel tank.

Engine coolant level Check the radiator reserve tank every time you fill the fuel tank.

Automatic transmission Check the fluid level monthly.

Brakes Check the fluid level monthly.

Tires Check the tire pressure monthly. Examine the tread for wear and foreign objects.

Lights Check the operation of the headlights, parking lights, taillights, high-mount brake light, and license plate lights monthly.

* 1 : If themessage ‘‘SERVICE’’ does not appear more than 12months after the

* 1 : If themessage ‘‘SERVICE’’ does not appear more than 12months after the display is reset, change the engine oil every year.

# : See information onmaintenance and emissions warranty in the center column.

NOTE: Independent of theMaintenanceMinder information, replace the brake fluid every 3 years.

Inspect idle speed every 160,000miles (256,000 km).

Adjust the valves during services A, B, 1, 2, or 3 if they are noisy.

Fluid Locations

    Important Maintenance Precautions
    If you have the required service done but do not reset the display, or reset the display without doing the service, the system will not show the correct maintenance intervals. This can lead ...

    Fluid Locations
    4-cylinder models V6 models ...

    See also:

    System Evacuation
    • Air conditioning refrigerant or lubricant v a p o r c an irritate your eyes, nose, or throat. •Be careful when connecting service equipment. • Do not breathe refrigerant or v ...

    A/C Compressor Clutch Circuit Troubleshooting
    NOTE: • It is normal for the A/C compressor to turn off under certain conditions, such as low idle, high engine coolant temperature, hard acceleration, or high/low refrigerant pressure. в ...

    Reverse Idler Gear Removal and Installation
    Removal 1. Remove the bolt (A) securing the reverse idler gear shaft holder (B). 2. Install a 5 x 0.8 mm bolt (C) in the reverse idler gear shaft (D), and pull it to remove the reverse idler gea ...