PGM-FI System

...

DTC Troubleshooting

DTC P0101: MAF Sensor Circuit Range/Performance Problem NOTE: - Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see ...

See also:

Secondary Shaft 1 st Gear Axial Clearance Inspection
Special Tools Required Attachment, 42 mm I.D. 07QAD-P0A0100 1. Remove the secondary shaft transmission housing bearing (see page 14-270). 2. Install the thrust needle b e a r i n g (A), the need ...

Status Log
If you suspect there is a immobilizer system problem, check the status log. 1. Connect the HDS to the data link connector. 2. Turn the ignition switch to ON (II). 3. On the HDS screen, at MAI ...

Fuel Pressure Regulator Replacement
1. Remove the fuel tank unit (see page 11-320). 2. Remove the reservoir (A). 3. Remove the bracket (B). 4. Remove the fuel pressure regulator (C). 5. Install the parts in the reverse order ...